Gripper42004 Posted December 15, 2002 Share Posted December 15, 2002 Does any body here have a Gripanator? I'm think I might get one. Quote Link to comment Share on other sites More sharing options...
Bill Piche Posted December 15, 2002 Share Posted December 15, 2002 Yes. It's the best out there for a crushing machine IMO. Quote Link to comment Share on other sites More sharing options...
Gripper42004 Posted December 15, 2002 Author Share Posted December 15, 2002 Thankx for the reply Wannagrip. :stuart Quote Link to comment Share on other sites More sharing options...
Rick Browne Posted December 16, 2002 Share Posted December 16, 2002 I like mine! It is built like a TANK!! Many options to dress it up also. I am happy with the following options.... ( I have the GLX model) *Extreme range adjustment angle *Beyond the range handle ( a definite on this ) *Padded arm rest I do have the negative assist arm but do not use it that much. I have the drilled feet.. but have not had to bolt it down to keep it from sliding around. I have used up to 130LBs and the machine sits there solid as a rock I opted for the standard 1 inch load pin. flexability use for olympic and standard plates in combination As far as the paint finish you decide what you want to spend on this.However, the red powder coating is nice. Good luck! Quote Link to comment Share on other sites More sharing options...
Rick Browne Posted December 16, 2002 Share Posted December 16, 2002 So as not to mislead, the 130lbs. was done using a negative crush technique. I used my free hand to help position the load in the closed position and then held on for dear life. I was not implying that I squeezed that weight alone with the working hand Please note this discalimer Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.