Guest woody36 Posted January 6, 2002 Share Posted January 6, 2002 Reading Kingpins post reminded me that my Girlfriend had previously bent a piece of CRS 6"x4mm in diameter awhile ago at my request. I just asked her if she could bend a 5 inch piece,and she said she'd give it a go.I'm proud to say she bent it with relative ease! i then cut some of my 5mm stock to 7 inches and she put an 1/2 inch bend in this piece of steel. She does no physical training whatsoever,and her hands only measure 3" across the palm. I'm going to try her with another piece in a few days if she'll let me,and see if she can better the bend. From now on whatever she says GOES! Quote Link to comment Share on other sites More sharing options...
Roark Posted January 6, 2002 Share Posted January 6, 2002 Woody, you and your lady friend give a whole new meaning to 'going on a bender' together. Her palm is only 3" across, so when she bent the 7" piece only 1/2" was overlapping each hand (assuming her hands were touching each other). Is she interested in progressing in bending? Quote Link to comment Share on other sites More sharing options...
Guest woody36 Posted January 6, 2002 Share Posted January 6, 2002 Joe, She has no interest in Steelbending and only tried because i asked,She doesn't think she did anything special and doesn't see what the fuss is about.If i could get her to practice,i don't think she would have a problem with the 5mm diameter.I've been smiling ever since she did it,and i feel incredibly proud of her,i don't know why i'm surprised she's been bending me round her little finger for years! Regards Ray. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.