Jump to content

FNL TY Edgins


Danny Young

Recommended Posts

I read a thread about these brand of edgins being the easiest. Does anyone know where I can get them? I was thinking about using them as a stepping stone to those triangle edgins. If not will just continue with 0-1 DR & 3/8" G2 bolts.

Link to comment
Share on other sites

FNL is Fastenal, you can check their website. Not sure about the TY.

Link to comment
Share on other sites

2 minutes ago, wobbler said:

FNL is Fastenal, you can check their website. Not sure about the TY.

Yeah I found their 5/16" grade 5 bolts. I hope I get some those FNL TY brands. I bent 2  8" edgins on Saturday.

Link to comment
Share on other sites

Any Edgin bends are beastly... so congrats on those bends Dan!  
from my experience FNL steel is consistently harder than most other sources.  
 

I remember bending a FML 6” edgin year’s ago in doubles...  the crush was insane!!  

good luck brother!

Rob
 

Link to comment
Share on other sites

On 11/15/2019 at 9:19 PM, robertmiller67 said:

Any Edgin bends are beastly... so congrats on those bends Dan!  
from my experience FNL steel is consistently harder than most other sources.  
 

I remember bending a FML 6” edgin year’s ago in doubles...  the crush was insane!!  

good luck brother!

Rob
 

To my knowledge there's a thread on this board stating "TY" brand edgins is the easiest of edgins. The hardest are the Triangle edgins. Which is the ones I always get from McMaster.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy policies.