wobbler Posted February 12, 2017 Share Posted February 12, 2017 I've got some 1/4" music wire (spring steel) that I want to use for iso bars. I've never tried to bend it, but assume that it's not going to move much. I know I want a straight piece or maybe just a slight kink, a 90* piece, and a few in between. Are there some common angles I should use? Quote Link to comment Share on other sites More sharing options...
Vice Posted March 2, 2017 Share Posted March 2, 2017 I'm just getting back into bending after a year break so I'm a little rusty, but the initial kink, 90 degrees, and the last half of the crushdown is where I would focus. Once you get the bar moving, are you able to take it to 90 most of the time? I feel like most ppl can go from 20 to 90 degrees the easiest, it's the other parts of the bend that are toughest, but that may vary a little for everyone. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.