Jump to content

Ben Edwards Certification


Bill Piche

Recommended Posts

Awesome! I'll be following along Ben.

BTW - I have an extra #3.5 that I could loan you, but I don't know what it calibrates at. It's definitely tougher than all 3 of my Elites though.

Thanks a lot Todd! That's a magnificent offer man. I'd love to use that #3.5 to work up to the MM3.

Ben, you can borrow my Adj. SE when we meet up for the axle hand-off. Hope that helps.

That kicks butt Josh! Thanks man!

Link to comment
Share on other sites

  • Replies 80
  • Created
  • Last Reply

Top Posters In This Topic

  • bencrush

    15

  • Bill Piche

    9

  • tmmicklabs

    8

  • twig

    3

Great news Ben.

You can do it! :rock

Link to comment
Share on other sites

Almost 4 years since my failure on the MM3 and I'm seriously considering another run at it if I get a gripper that is relatively close in what I guess the MM3 calibrates at. Somewhere in the high 170s to low 180s.
I've got a 175lbs call'd 3.5 I'll glady loan you.
Not looking for any "You can do it!" posts
You can do it!
Link to comment
Share on other sites

Awesome! I'll be following along Ben.

BTW - I have an extra #3.5 that I could loan you, but I don't know what it calibrates at. It's definitely tougher than all 3 of my Elites though.

Thanks a lot Todd! That's a magnificent offer man. I'd love to use that #3.5 to work up to the MM3.

No problem Ben! If you would like to borrow my 3.5, just shoot me a PM of where to send it to.

Link to comment
Share on other sites

No problem Ben! If you would like to borrow my 3.5, just shoot me a PM of where to send it to.

PM sent, thanks again!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy policies.